Keithley 6430 Instruction Manual page 51

Table 1-3
Factory default settings
Setting
A/D Controls:
Auto-zero
Line frequency
Beeper
Data Store
Digital output*
Digits
FCTN
Filter:
Auto filter
Moving filter count**
Advanced filter
Median filter rank**
Repeat filter count**
GPIB address
Guard
Limit tests:
DigOut:
Size
Mode:
Binning control
Auto clear:
Delay
Clear pattern*
H/W limits:
Control
Fail mode:
Cmpl pattern*
S/W limits:
Lim 2, 3, 5-12:
Control
Low limit:
Low pattern*
High limit:
High pattern*
Pass (all tests):
Pass pattern*
Source memory location Next
EOT mode
Numbers
Ohms source mode
Offset compensated ohms
Output
Interlock
Off state
Auto-off
* 15 if digout size is 4-bit, 7 if digout size is 3-bit.
** Changes with range when auto filter is enabled.
BENCH default GPIB default
On On
No effect No effect
On On
No effect No effect
15 or 7 15 or 7
5.5 5.5
Power (off) Power (off)
On On
On On
1 1
Off (5% noise tol) Off (5% noise tol)
0 0
1 1
No effect No effect
Cable Cable
4-bit 4-bit
Grading Grading
Immediate Immediate
Disabled Disabled
0.00001 sec 0.00001 sec
15 or 7 15 or 7
Disabled Disabled
In compliance In compliance
15 or 7 15 or 7
Disabled Disabled
-1.0 -1.0
15 or 7 15 or 7
+1.0 +1.0
15 or 7 15 or 7
15 or 7 15 or 7
Next
EOT EOT
No effect No effect
Manual Manual
Off Off
Off Off
Disabled Disabled
Normal Normal
Disabled Disabled
Getting Started 1-19