Reference Tables - Keithley 6430 Instruction Manual

17-2 SCPI Command Reference

Reference tables

Tables 17-1 through 17-10 summarize the commands for each SCPI subsystem. The follow-
ing list includes the SCPI subsystem commands, the table number where each command is
summarized, and the reference page where detailed information begins.
Summary table
17-1
17-2
17-3
17-4
17-5
17-6
17-7
17-8
17-9
17-10
General notes:
Brackets ([ ]) are used to denote optional character sets. These optional characters do not
have to be included in the program message. Do not use brackets in the program message.
Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets in the
program message.
The Boolean parameter (<b>) is used to enable or disable an instrument operation. 1 or ON
enables the operation, and 0 or OFF disables the operation.
Upper case characters indicate the short-form version for each command word.
Default Parameter — Listed parameters are both the *RST and :SYSTem:PRESet defaults,
unless noted otherwise. Parameter notes are located at the end of each table.
SCPI — A checkmark (✓) indicates that the command and its parameters are SCPI con-
firmed. An unmarked command indicates that it is a SCPI command, but does not conform to
the SCPI standard set of commands. It is not a recognized command by the SCPI consortium.
SCPI confirmed commands that use one or more non-SCPI parameters are explained by notes.
Source Memory — A checkmark (✓) indicates that the parameters associated with the
specified command are saved in any one of 100 memory locations by the
:SOURce[1]:MEMory:SAVE command.
Subsystem Reference page
CALCulate 17-22
DISPlay 17-41
FORMat 17-44
OUTPut 17-52
SENSe 17-54
SOURce 17-64
STATus 17-86
SYSTem 17-89
TRACe 17-99
TRIGger 17-102