Figure - Keithley 6430 Instruction Manual

1-30 Getting Started
Table 1-8
Trigger configuration menu
Configuration menu item
CONFIG TRIG
CONFIGURE TRIGGER
ARM LAYER
ARM IN
ARM OUT
COUNT
TRIG LAYER
TRIGGER IN
TRIGGER OUT
DELAY
COUNT
HALT
IMMEDIATE
GPIB
TIMER
MANUAL
TLINK
ONCE
NEVER
↓STEST
ONCE
NEVER
↑STEST
ONCE
NEVER
↑↓STEST
ONCE
NEVER
LINE
EVENTS
TRIG LAYER EXIT
TL ENTER
FINITE
INFINITE
IMMEDIATE
TRIGGER LINK
LINE
EVENTS
Description
Configure triggering.
Configure trigger model arm layer.
Select arm layer detection event.
Immediate event detection.
GPIB GET or *TRG.
After timer interval elapses, enter interval.
Front panel TRIG key.
Enter TLINK line and state.
Bypass event detection once.
Never bypass event detection.
When Digital I/O SOT line is pulsed low.
Bypass event detection once.
Never bypass event detection.
When Digital I/O SOT is pulsed high.
Bypass event detection once.
Never bypass event detection.
When Digital I/O SOT line is pulsed high or low.
Bypass event detection once.
Never bypass event detection.
Configure arm layer output trigger.
Select trigger link output line (1-4).
Enable/disable events.
Enable (ON) or disable (OFF) on exiting trigger layer.
Enable (ON) or disable (OFF) on entering trigger layer.
Specify arm count.
Programmable count.
Never ending count.
Configure trigger layer of trigger model.
Select trigger layer detection event.
Trigger event occurs immediately.
Select trigger link line as event (1-4).
Configure trigger layer output trigger.
Select trigger link line (1-4).
Enable (ON) or disable (OFF) for SOURCE, DELAY,
and MEAS.
Program trigger delay time.
Program trigger count.
Return unit to idle state.