Keithley 6430 Instruction Manual page 40

1-8 Getting Started
Operation keys:
EDIT
TOGGLE
LOCAL
REL
FILTER
LIMIT
TRIG
SWEEP
and
DIGITS
SPEED
STORE
RECALL
CONFIG
MENU
EXIT
ENTER
RANGE keys:
▲
▼
AUTO
Annunciators:
EDIT
ERR
REM
TALK
LSTN
SRQ
REAR
REL
FILT
MATH
4W
AUTO
ARM
TRIG
*
Source control:
ON/OFF
Handle:
Pull out and rotate to desired position.
Select source or compliance reading for editing.
Toggle display positions of source and measure readings, or display V and I
measurements.
Cancel remote operation.
Enable/disable relative reading on present function.
Display digital filter status for present function and toggle filter on/off.
Perform configured limit tests.
Trigger a measurement from the front panel.
Start configured sweep.
Move through parameter values or selections within functions and operations.
Change number of digits of display resolution.
Change measurement speed by selecting accuracy or specifying NPLC.
Set buffer size and enable reading storage.
Display stored readings and timestamp.
Press CONFIG and then appropriate key to configure function or operation.
Access and configure Main Menu selections. When entering numeric data, use to
clear reading to minimum absolute value.
Cancels selection. Use to back out of menu structures.
Accepts selection.
Moves to next higher range, increments digit, moves to next selection.
Moves to next lower range, decrements digit, moves to previous selection.
Enables or disables measurement auto range.
Instrument in edit mode.
Questionable reading, invalid cal step.
Instrument in GPIB remote mode.
Instrument addressed to talk over GPIB.
Instrument addressed to listen over GPIB.
Service request over GPIB.
On = Remote Preamp not connected. Off = Remote Preamp connected.
Relative measure reading displayed.
Digital filter enabled.
Math function enabled.
Remote sensing enabled.
Autoranging enabled.
Source-measure operations being performed.
External trigger source selected.
Reading being stored.
Turns the source on or off.