Configure List - Keithley 6430 Instruction Manual

17-76 SCPI Command Reference
Configure list
:CURRent <NRf list>
:VOLTage <NRf list>
:SOURce[1]:LIST:CURRent <NRf list>
:SOURce[1]:LIST:VOLTage <NRf list>
Parameters
Query
Description
NOTE
:APPend <NRf list>
:SOURce[1]:LIST:CURRent:APPend <NRf list>
:SOURce[1]:LIST:VOLTage:APPend <NRf list>
Parameters
Description
<NRf list> = NRf, NRf ... NRf
NRf = -105e-3 to 105e-3
-210 to 210
:CURRent?
:VOLTage?
These commands are used to define a list of source values (up to 100) for the
list sourcing mode of operation. When operation is started, the instrument
will sequentially source each current or voltage value in the list. A measure-
ment is performed at each source level.
The following command shows the proper format for defining an I-Source
list using current source values of 10mA, 130mA, and 5mA:
:SOURce[1]:LIST:CURRent 0.01, 0.13, 0.005
If using manual source ranging, you can use auto range for source values
that are not within a single range.
In order to execute a source list, the selected source must be in the list sourcing
mode, and the product of the arm and trigger count should be at least the same as
the number of source points in the list.
Use the :FUNCtion:MODE command to select the current or voltage source
function. See Select function mode. Use the :CURRent:MODE or
VOLTage:MODE command to select the LIST sourcing mode. See Select
sourcing mode. The trigger count is set using the TRIGger:COUNt
command. See Trigger subsystem.
<NRf list> = NRf, NRf ... NRf
NRf = -105e-3 to 105e-3
-210 to 210
This command is used to add one or more values (up to 100) to a source list
that already exists. The source values are appended to the end of the list. (By
using multiple appended lists, up to 2500 points can be in a list.)
Define I-Source list
Define V-Source list
I-Source value
V-Source value
Query I-Source list
Query V-Source list
Add value(s) to I-Source list
Add value(s) to V-Source list
I-Source value
V-Source value