Source Delay - Keithley 6430 Instruction Manual

Sub-femtoamp remote sourcemeter

Hide thumbs Also See for 6430:

Table of Contents

Front panel V-source protection

To program V-source protection from the front panel:

Press CONFIG then SOURCE V.

Select PROTECTION from the displayed choices, then press ENTER.

Select the desired protection value, then press ENTER.

Press EXIT to return to normal display.

Remote command V-source protection

Use the :SOURce:VOLTage:PROTection command to program the V-source protection

value via remote. See Section 17 for details. For example, the following command sets the pro-

tection value to 20V:

:SOUR:VOLT:PROT 20

Source delay

The source delay options are used to set the settling time for the source. This source delay is

the delay phase of the Source-delay-measure cycle . See Section 5. The auto delay period is cur-

rent range dependent (Table 3-4).

Auto source delay

Manual delay can be set from 0000.00000 to 9999.99800 seconds. Manually setting the

delay disables auto delay.

Basic Source-Measure Operation

Table of Contents