Clear Test Results - Keithley 6430 Instruction Manual

:MODE <name>
:CALCulate2:CLIMits:MODE <name>
Parameters
Query
Description

Clear test results

[:IMMediate]
:CALCulate2:CLIMits:CLEar[:IMMediate]
Description
:AUTO <b>
:CALCulate2:CLIMits:CLEar:AUTO <b>
Parameters
Query
Description
<name> = GRADing
SORTing
:MODE?
This command controls how limit calculations drive the Digital I/O lines. In
GRADing mode, a reading passes if it is within all of the hi/low limit toler-
ances enabled, assuming that it has passed LIMIT 1 compliance test first.
The Digital I/O lines will be driven with the first pattern of the first compli-
ance, hi, or low failure. Otherwise, the CALC2:CLIM:PASS:SOUR2 pat-
tern will be output.
In SORTing mode, a reading will fail if it fails the compliance test, or is not
within any of the Digital I/O Bands. If the tests pass and only LIMIT 1 is
enabled, the CALC2:CLIM:PASS:SOUR2 pattern will be output. Other-
wise, the first limit test band that passes will output its LOW:SOUR2 pattern
(UPP:SOUR2 patterns will be ignored). If LIMIT1 fails, its SOUR2 pattern
will be output. If no LIMIT2, 3, 5-12 limit passes, the
CALC2:CLIM:FAIL:SOUR2 pattern will be output.
This command clears the test results (pass or fail) of the limit tests and
resets the output lines of the Digital I/O port back to the :SOURce2:TTL
settings. See SOURce2.
<b> = 1 or ON
0 or OFF
:AUTO?
With auto-clear enabled, test results will clear and the output lines of the
Digital I/O port will reset when the :INITiate command is sent to start a new
test sequence.
When disabled, you must use :IMMediate to perform the clear actions.
SCPI Command Reference
Control Digital I/O port pass/fail output
Output graded "pass/fail" pattern
Output sorted "pass/fail" pattern
Query Digital I/O pass/fail mode
Clears test results and resets Digital I/O
Port
Control auto-clear for test results
Enable auto-clear
Disable auto-clear
Query state of auto-clear
17-39