Keithley 6430 Instruction Manual page 372

17-62 SCPI Command Reference
:MEDian[:STATe] <b>
[:SENSe[1]]:MEDian[:STATe] <b>
Parameters
Query
Description
Moving filter commands
:AVERage:COUNt <n>
[:SENSe[1]]:AVERage:COUNt <n>
Parameters
Query
Description
:AVERage[:STATe] <b>
[:SENSe[1]]:AVERage[:STATe] <b>
Parameters
Query
Description
<b> = 0 or OFF
1 or ON
[:STATe]?
This command is used to enable or disable the median filter. When enabled,
voltage, current, and resistance readings are filtered according to the speci-
fied rank. When disabled, the median filter stage is bypassed.
<n> = 1 to 100
DEFault
MINimum
MAXimum
:COUNt?
:COUNt? DEFault
:COUNt? MINimum
:COUNt? MAXimum
This command is used to specify the moving filter count. In general, the fil-
ter count is the number of readings that are stored in the moving filter buffer
for the averaging calculation. After the buffer fills with readings, a new
reading goes into the buffer and the oldest reading is discarded. The filter
process if performed after each new reading is placed in the buffer.
<b> = 0 or OFF
1 or ON
[:STATe]?
This command is used to enable or disable the moving filter. When enabled,
voltage, current, and resistance readings are filtered according to how the
filter is configured. When disabled, the moving filter stage is bypassed.
Enable/disable median filter
Disable repeat filter
Enable repeat filter
Query state of repeat filter
Set moving filter count
Specify moving filter count
1
1
100
Query filter count
Query the *RST default filter count
Query the lowest allowable filter count
Query the largest allowable filter count
Enable/disable moving filter
Disable moving filter
Enable moving filter
Query state of moving filter