Keithley 6430 Instruction Manual page 366

17-56 SCPI Command Reference
NOTE
Description
:RESistance:MODE <name>
[:SENSe[1]]:RESistance:MODE <name>
Parameters
Query
Description
:RESistance:OCOMpensated <b>
[:SENSe[1]]:RESistance:OCOMpensated <b>
Parameters
Query
Description
NOTE
The function name must be enclosed in double or single quotes (i.e., :func:stat?
"volt").
This command is used to query the state of the specified measurement func-
tion. A returned response message of "0" indicates that the specified func-
tion is disabled, while a "1" indicates that the function is enabled.
<name> = MANual
AUTO
:MODE?
This command is used to select the ohms measurement mode. With
MANual ohms selected, the user must configure the source and measure
aspects of the operation. When the ohms function is selected, the ohms
reading is simply the result of the V/I calculation.
Range changes cannot be made in manual ohms.
With AUTO ohms selected, the SourceMeter will be configured to Source I
Measure V when the ohms function is selected. The current source value
and voltage measurement range used depend on the ohms measurement
range that is selected.
See Section 4 for details on manual and auto ohms.
<b> = 1 or ON
0 or OFF
:OCOMpensated? Query state of offset compensation
This command is used to enable or disable offset-compensated ohms. When
using the auto ohms measurement mode, the current source level is automat-
ically set. When using the manual ohms measurement mode, you must set
the source (V or I) output level.
See Section 4, Offset-compensated ohms for details on making offset-
compensated ohms measurements.
Offset-compensated ohms will disable when the :MEASure? command (for the resis-
tance function) or the :CONFigure:RESistance command is sent.
Select ohms measurement mode
Manual ohms mode
Auto ohms mode
Query ohms mode
Control offset-compensated ohms
Enable offset compensation
Disable offset compensation