Declaration Of Conformity For Rf Exposure - Cisco AIR-PCM342 Hardware Installation Manual

Declaration of Conformity for RF Exposure

Note
Note

Declaration of Conformity for RF Exposure

Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
C-6
For the 350 series, the following standards were applied:
Radio: EN 300.328-1, EN 300.328-2
•
EMC: EN 301 489-1, EN 301 489-17
•
• Safety: EN 60950
The following CE mark is affixed to the 350 series equipment:
The above CE mark is required as of April 8, 2000 but might change in the future.
This equipment is intended to be used in all EU and EFTA countries.
Outdoor use may be restricted to certain frequencies and/or may
require a license for operation. For more details, contact Cisco
Corporate Compliance.
Combinations of power levels and antennas resulting in a radiated
power level of above 100 mW equivalent isotropic radiated power
(EIRP) are considered as not compliant with the above mentioned
directive and are not allowed for use within the European
community and countries that have adopted the European R&TTE
directive 1999/5/EC and/or the CEPT recommendation Rec 70.03.
For more details on legal combinations of power levels and
antennas, contact Cisco Corporate Compliance.
The radio module has been evaluated under FCC Bulletin OET 65C and found
compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and
15.247 (b) (4) addressing RF Exposure from radio frequency devices.
Appendix C Declarations of Conformity and Regulatory Information
OL-0795-01