Using The Gui To Configure An Rf Group - Cisco OL-8335-02 Configuration Manual

Chapter 9 Configuring Radio Resource Management

Using the GUI to Configure an RF Group

Follow these steps to create an RF group using the GUI.
Click Controller > General to access the General page (see
Step 1
Figure 9-1
Enter a name for the RF group in the RF-Network Name field. The name can contain up to 19 ASCII
Step 2
characters.
Click Save Configuration to save your changes.
Step 3
Repeat this procedure for each controller that you want to include in the RF group.
Step 4
OL-8335-02
General Page
Figure 9-1).
Cisco Wireless LAN Controller Configuration Guide
Configuring an RF Group
9-7