Using The Gui To Configure Access Control Lists - Cisco SD2008T-NA Configuration Manual

Chapter 5 Configuring Security Solutions

Using the GUI to Configure Access Control Lists

Follow these steps to configure ACLs using the controller GUI.
Click Security > Access Control Lists to access the Access Control Lists page (see
Step 1
Figure 5-2
This page lists all of the ACLs that have been configured for this controller. It also enables you to edit
or remove any of the ACLs.
To add a new ACL, click New. The Access Control Lists > New page appears (see
Step 2
Figure 5-3
In the Access Control List Name field, enter a name for the new ACL. You can enter up to 32
Step 3
alphanumeric characters.
Click Apply. When the Access Control Lists page reappears, click the Edit link for the new ACL.
Step 4
OL-9141-03
Access Control Lists Page
Access Control Lists > New Page
Configuring Access Control Lists
Cisco Wireless LAN Controller Configuration Guide
Figure 5-2).
Figure 5-3).
5-9