Example For Configuring A Single Rrpp Ring With Multiple Instances - Huawei Quidway S6700 series Configuration Manual

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
3.6.4 Example for Configuring a Single RRPP Ring with Multiple
Instances
Networking Requirements
As shown in
ring.
Two rings are involved in the networking, ring 1 in domain 1 and ring 1 in domain 2.
VLANs 100 to 300 are configured on CE. Domain 1 and domain 2 share the traffic of packets
from VLANs 100 to 300. Packets from VLANs 100 to 200 are transmitted through domain 1,
and packets from VLANs 201 to 300 are transmitted through domain 2.
Table 3-1
2.
Table 3-1 Mapping between protected VLANs and instances
Ring
ID
Domain
1
Domain
2
Table 3-2
master node.
Table 3-2 Master nodes, and primary and secondary ports on the master nodes
Ring ID
Ring 1 in domain 1
Ring 1 in domain 2
Issue 01 (2011-07-15)
#
interface XGigabitEthernet 0/0/2
port hybrid tagged vlan 10 to 11
stp disable
#
return
Figure 3-8, UPE A, UPE B, UPE C, and PE-AGG form a multi-instance RRPP
shows the mapping between protected VLANs and instances in domain 1 and domain
Control VLAN
ID
VLAN 5, VLAN 6
VLAN 10, VLAN
11
shows the master node of each ring, and the primary port and secondary port on the
Master Node
PE-AGG
PE-AGG
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Instance ID of Data VLAN ID
Control VLAN
Instance 1 VLAN 100-200
Instance 2 VLAN 201-300
Primary Port
XGE0/0/1
XGE0/0/2
3 RRPP Configuration
Instance ID of
Data VLAN
Instance 1
Instance 2
Secondary Port
XGE0/0/2
XGE0/0/1
97