Filtering Out All Alarms; Configuring An Alarm Filtering Table To Filter Out Alarms - Huawei NetEngine5000E Configuration Manual

HUAWEI NetEngine5000E Core Router
Configuration Guide - System Management
Disable alarm suppression immediately after it is not required. Otherwise, a large number of
redundant alarms will be generated.
Step 4 Run:
commit
The configuration is committed.
----End

5.3.4 Filtering Out All Alarms

Terminal users can filter out all alarms.
Context
Terminal users include command line users and NMS users. If terminal users do not expect any
alarms sent from the device, they can filter out all alarms.
Procedure
l
l
----End

5.3.5 Configuring an Alarm Filtering Table to Filter Out Alarms

This section describes how to edit and apply an alarm filtering table. An alarm filtering table
can be used by different terminal users to filter out the alarms that they are not concern about.
Context
Terminal users include command line users and NMS users. Different users are concerned about
different types of alarms. Terminal users can configure an alarm filtering table to filter out the
unwanted alarms.
Flexible filtering rules can be defined in an alarm filtering table.
l
l
l
Issue 01 (2011-10-15)
CAUTION
Command line users run the undo terminal alarm command in the user view to filter out
all alarms.
NMS users on the host named host-name perform the following operations to filter out all
alarms:
1. Run the system-view command to enter the system view.
2. Run the alarm command to enter the alarm management view.
3. Run the undo alarm snmp target-host host-name command to filter out all alarms.
Filtering out alarms with the specific severity, such as alarms with the severity lower than
Major
Filtering out alarms that are generated for a specific service, such as alarms for the MPLS
service
Filtering out alarms with specific names, such as an LDP session alarm
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Fault Management
117