Installing And Removing; M Anagement M Odule - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
3. Pull the card ejectors towards you, and away from the module front panel. The card will unseat from the
backplane.
4. Pull the module out of the chassis and place in an anti-static bag for storage.
5. Cover the slot with the blank face plate that shipped with the chassis.
CAUTION: If you remove a module and do not replace it, cover the slot opening with one of the blank plates
you received with the Routing Switch to provide additional safety and airflow for the system.
NOTE: Modules can be installed and removed when the unit is powered on (hot swap). There is no need to
power the system down. You do not need to change the slot's configuration unless you plan to insert a
different type of module. Refer to "Swapping Modules" on page 2-34.
Installing and Removing (Optional) Mini-GBICs
This section provides installation information for the following HP ProCurve Mini-GBIC products:
• J4858A HP ProCurve Gigabit-SX-LC Mini-GBIC: Supports multi-mode fiber; LC connector.
• J4859A HP ProCurve Gigabit-LX-LC Mini-GBIC: Supports single-mode and multi-mode fiber; LC connector.
(Multi-Mode LX supports a shorter distance than single-mode LX.)
• J4860A HP ProCurve Gigabit LH-LC Mini-GBIC: Supports single-mode fiber; LC connector.
You can install any combination of the above mini-GBICs in the HP Procurve 9300 mini-GBIC modules listed in
the following note.
NOTE: To use a Mini-GBIC, you must install it in either of the Mini-GBIC modules described below. This
document assumes that you have already installed at least one of these modules in your HP Procurve Routing
Switch 9304M, 9308M, or 9315M:
• J4856A HP ProCurve 9300 Mini-GBIC Module
• J4857A HP ProCurve 9300 Mini-GBIC Redundant Management Module
• J4894A HP ProCurve 9300 EP Mini-GBIC Module
• J4895A HP ProCurve 9300 EP Mini-GBIC Redundant Management Module
For information on installing a module in your routing switch, refer to either the printed Quick Start Guide or the
electronic (PDF) Installation and Configuration Guide (on the Documentation CD-ROM ) shipped with the routing
switch chassis or management module. For a downloadable copy of the latest edition of these documents and
other routing switch product documentation, visit http://www.hp.com/go/procurve and go to the technical
support area.
2 - 6