Displaying T-Flow Module Information; Displaying The Software Version Running On The Module - HP ProCurve 9304M Installation And Configuration Manual

• show mac-address – Shows the MAC table.
• show running-config – Shows the running-config.
• show usage – Shows Layer 4 session table information.
• show trunk – Shows trunk group information.
• show vlans – Shows VLAN information.
• write terminal – Displays the running-config on the management console.
With a few exceptions, the command syntax and displays are the same as described in the Command Line
Interface Reference . Here are the exceptions:
• T he show ip route command displays only 20 entries at a time. The command has an optional parameter,
<num>, that indicates the entry at which you want the display to begin.
• The output of the show trunk and show vlans commands is different from the output format for these
commands when entered on the MP.

Displaying T-Flow Module Information

You can display the following T-Flow information:
• Software versions – see "Displaying the Software Version Running on the Module" on page 4-9
• General module information – "Displaying General Module Information" on page 4-11
• Module status – see "Determining Module Status" on page 4-12
• Slot allocations for the TSPs – see "Determining the Slot Allocations for the TSPs" on page 4-14
The commands in this section are supported on the MP, not on the TSPs.

Displaying the Software Version Running on the Module

To display the software version running on the T-Flow, use either of the following methods.
Using the T-Flow Redundant Management Module
4 - 9