HP ProCurve 9304M Installation And Configuration Manual page 417

This display shows the following information.
Table 12.3: CLI Display of Summary VLAN Information for GVRP
This Field...
Number of VLANs in the GVRP
Database
Maximum Number of VLANs that can
be present
VLAN-ID
MODE
VLAN-INDEX
To display detailed information for a specific VLAN, enter a command such as the following:
HP9300(config)# show gvrp vlan 1001
VLAN-ID: 1001, VLAN-INDEX: 7, STATIC: NO, DEFAULT: NO, BASE-VLAN: NO
Timer to Delete Entry Running: NO
Legend: [S=Slot]
Forbidden Members: None
Fixed Members: None
Normal(Dynamic) Members: (S2)
This display shows the following information.
Table 12.4: CLI Display of Summary VLAN Information for GVRP
This Field...
VLAN-ID
VLAN-INDEX
STATIC
Configuring GARP VLAN Registration Protocol (GVRP)
Displays...
The number of VLANs in the GVRP database.
Note: This number includes the default VLAN (1), the GVRP base
VLAN (4093), and the single STP VLAN (4094). These VLANs are
not advertised by GVRP but are included in the total count.
The maximum number of VLANs that can be configured on the
device. This number includes statically configured VLANs, VLANs
learned through GVRP, and VLANs 1, 4093, and 4094.
To change the maximum number of VLANs the device can have, use
the system-max vlan <num> command. See "Displaying and
Modifying System Parameter Default Settings" on page 6-44.
The VLAN ID.
The type of VLAN, which can be one of the following:
• STATIC – The VLAN is statically configured and cannot be
removed by GVRP. This includes VLANs you have configured as
well as the default VLAN (1), base GVRP VLAN (4093), and
Single STP VLAN (4094).
• DYNAMIC – The VLAN was learned through GVRP.
A number used as an index into the internal database.
1
Displays...
The VLAN ID.
A number used as an index into the internal database.
Whether the VLAN is a statically configured VLAN.
12 - 13