Dynamic Core And Dynamic Edge - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable all
These commands globally enable GVRP support and enable the protocol on all ports.
Enter the following commands on edge device A:
HP9300> enable
HP9300# configure terminal
HP9300(config)# vlan 20
HP9300(config-vlan-20)# untag ethernet 2/1
HP9300(config-vlan-20)# tag ethernet 4/24
HP9300(config-vlan-20)# vlan 40
HP9300(config-vlan-40)# untag ethernet 2/1
HP9300(config-vlan-40)# tag ethernet 4/24
HP9300(config-vlan-40)# exit
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable ethernet 4/24
HP9300(config-gvrp)# block-learning ethernet 4/24
These commands statically configure two port-based VLANs, enable GVRP on port 4/24, and block GVRP
learning on the port. The device will advertise the VLANs but will not learn VLANs from other devices.
Enter the following commands on edge device B:
HP9300> enable
HP9300# configure terminal
HP9300(config)# vlan 20
HP9300(config-vlan-20)# untag ethernet 2/24
HP9300(config-vlan-20)# tag ethernet 4/1
HP9300(config-vlan-20)# vlan 30
HP9300(config-vlan-30)# untag ethernet 4/24
HP9300(config-vlan-30)# tag ethernet 4/1
HP9300(config-vlan-30)# exit
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable ethernet 4/1
HP9300(config-gvrp)# block-learning ethernet 4/1
Enter the following commands on edge device C:
HP9300> enable
HP9300# configure terminal
HP9300(config)# vlan 30
HP9300(config-vlan-30)# untag ethernet 2/24
HP9300(config-vlan-30)# tag ethernet 4/1
HP9300(config-vlan-20)# vlan 40
HP9300(config-vlan-40)# untag ethernet 4/24
HP9300(config-vlan-40)# tag ethernet 4/1
HP9300(config-vlan-40)# exit
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable ethernet 4/1
HP9300(config-gvrp)# block-learning ethernet 4/1

Dynamic Core and Dynamic Edge

In this configuration, the core and edge devices have no statically configured VLANs and are enabled to learn and
advertise VLANs. The edge and core devices learn the VLANs configured on the devices in the edge clouds. To
enable GVRP on all the ports, enter the following command on each edge device and on the core device.
HP9300> enable
HP9300# configure terminal
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable all
12 - 18