HP ProCurve 9304M Installation And Configuration Manual page 300

Installation and Basic Configuration Guide
Displaying Topology Group Information
To display topology group information, enter the following command:
HP9300(config)# show topology-group
Topology Group 3
=================
master-vlan 2
member-vlan none
Common control ports
ethernet 1/1
ethernet 1/2
ethernet 1/5
ethernet 2/22
Per vlan free ports
ethernet 2/3
ethernet 2/4
ethernet 2/11
ethernet 2/12
Syntax: show topology-group [<group-id>]
This display shows the following information.
This Field...
master-vlan
member-vlan
Common control ports
L2 protocol
Per vlan free ports
10 - 4
L2 protocol
MRP
MRP
VSRP
VSRP
Vlan 2
Vlan 2
Vlan 2
Vlan 2
Table 10.1: CLI Display of Topology Group Information
Displays...
The master VLAN for the topology group. The settings for STP, MRP,
or VSRP on the control ports in the master VLAN apply to all control
ports in the member VLANs within the topology group.
The member VLANs in the topology group.
The master VLAN ports that are configured with Layer 2 protocol
information. The Layer 2 protocol configuration and state of these
ports in the master VLAN applies to the same port numbers in all the
member VLANs.
The Layer 2 protocol configured on the control ports. The Layer 2
protocol can be one of the following:
• MRP
• STP
• VSRP
The ports that are not controlled by the Layer 2 protocol information in
the master VLAN.