HP ProCurve 9304M Installation And Configuration Manual page 105

Using the 2-Port 10-Gigabit Ethernet Module
NOTE: For information on installing or removing either a 10-Gigabit Ethernet module or the XENPAK optics used
with the J8174A 2-port 10-Gigabit Ethernet module, refer to any of the following:
• Chapter 2, "Installation" on page 2-1
• Quick Start Guide for the HP ProCurve Routing Switches 9304M, 9308M, 9315M , Edition 2, September 2003
or later. (This edition is included with 9300M series chassis models shipped after October 15, 2003.)
• Removing and Installing XENPAK Optics , an instruction sheet included in the Documentation CD shipped
with HP ProCurve Series 9300 modules
HP periodically updates the Routing Switch 9300M series documentation. You can download the latest version of
the documentation for your Routing Switch by visiting the HP Procurve website at:
Click on technical support, then manuals.
This chapter describes the HP 2-port 10-Gigabit Ethernet modules. It contains the following topics:
• "1-Port 10 Gigabit Ethernet Module (Discontinued)" below
• "2-Port 10-Gigabit Ethernet Modules with XENPAK Optics" on page 5-2
• "Cleaning the Fiber Optic Connectors" on page 5-3
• "Cabling 10 Gigabit Ethernet Modules" on page 5-4
• "Port LEDs" on page 5-4
• "Troubleshooting Network Connections" on page 5-4
• "Upgrading an FPGA on a 10 Gigabit Ethernet Module" on page 5-5
1-Port 10 Gigabit Ethernet Module (Discontinued)
The 1-port 10 Gigabit Ethernet module provides the following types of 10 Gigabit Ethernet interfaces:
• 1310nm serial for single-mode fiber - part number J4891A
Figure 5.1 shows the front panel of a 1-port 10 Gigabit Ethernet module.
http://www.hp.com/go/hp/procurve
Chapter 5
5 - 1