Installing And Removing A Power Supply - HP 5130-24G-4SFP+ EI Installation Manual

Figure 16 Grounding through the PE wire of the AC power cord
(1) Chassis rear panel
NOTE:
To guarantee the grounding effect, use the grounding cable provided with the switch to connect to the
grounding strip in the equipment room as long as possible.

Installing and removing a power supply

The HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch provides two power supply slots
and comes with power supply slot 1 empty and a filler panel in power supply slot 2. You can install one
power supply, or two power supplies for redundancy. For information about power supplies available for
the HP 5130-24G-SFP-4SFP+ EI/HP 5130-24G-SFP-4SFP+ EI TAA switch, see
When two power supplies are installed, you can hot-swap a power supply. To avoid device damage and
bodily injury, follow the procedures in
Figure 17 Installation procedure
Figure 18 Removal procedure
The installation and removal procedures are the same for the PSR150-A1, PSR150-A, and PSR150-D1
power supplies. This guide uses the PSR150-A power supply as an example.
(2) Three-wire AC power cable
Figure 17 and Figure 18
16
"Appendix B
to install and replace a power supply.
FRUs."