HP ProCurve 9304M Installation And Configuration Manual page 78

Installation and Basic Configuration Guide
NOTE: The change does not take effect until you reload the system. If you save the change to the active
module's system-config file before reloading, the change persists across system reloads. Otherwise, the change
affects only the next system reload.
USING THE CLI
To override the default and specify the active redundant management module, enter the following commands:
HP9300(config)# redundancy
HP9300(config-redundancy)# active-management 5
Syntax: active-management <slot-num>
The <slot-num> parameter specifies the chassis slot:
• Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
• Slots in an 8-slot chassis are numbered 1 – 8, from left to right.
• Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
This command overrides the default and makes the redundant management module in slot 5 the active module
following the next reload. The change affects only the next reload and does not remain in effect for future reloads.
To make the change permanent across future reloads, enter the write memory command to save the change to
the startup-config file, as shown in the following example:
HP9300(config)# redundancy
HP9300(config-redundancy)# active-management 5
HP9300(config-redundancy)# write memory
NOTE: If you do not save the change to the startup-config file, the change affects only the next reload.
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Redundant link to display the following panel.
3. Select slot number for the active redundant management module from the Active Management Slot pulldown
menu. If you use the default value, Auto Select, the Chassis device uses the redundant management module
in the lower slot number.
• Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
3 - 6