Specifying A Syslog Server; Specifying An Additional Syslog Server - HP ProCurve 9304M Installation And Configuration Manual

16. Click on the Add button to add the server to the list. You can add up to six Syslog servers.
17. When you have finished, select the Save link at the bottom of the dialog. Select Yes when prompted to save
the configuration change to the startup-config file on the device's flash memory.
Disabling or Re-Enabling Syslog
Syslog is enabled by default. To disable or re-enable it, use one of the following methods.
USING THE CLI
To disable it, enter the following command at the global CONFIG level:
HP9300(config)# no logging on
Syntax: [no] logging on [<udp-port>]
The <udp-port> parameter specifies the application port used for the Syslog facility. The default is 514.
To re-enable logging, enter the following command:
HP9300(config)# logging on
This command enables local Syslog logging with the following defaults:
• Messages of all severity levels (Emergencies – Debugging) are logged.
• Up to 50 messages are retained in the local Syslog buffer.
• No Syslog server is specified.

Specifying a Syslog Server

To specify a Syslog server, use one of the following methods.
USING THE CLI
Enter a command such as the following:
HP9300(config)# logging 10.0.0.99
Syntax: logging <ip-addr> | <server-name>
USING THE WEB MANAGEMENT INTERFACE
See the section "Displaying and Configuring Syslog Buffer Parameters Using the Web Management Interface" on
page A-7.
NOTE: You can specify a server name only if you have already configured the DNS Resolver feature. See the
"Configuring IP" chapter in the Advanced Configuration and Management Guide .

Specifying an Additional Syslog Server

USING THE CLI
To specify an additional Syslog server, enter the logging <ip-addr> command again, as in the following example.
You can specify up to six Syslog servers.
HP9300(config)# logging 10.0.0.69
Syntax: logging <ip-addr> | <server-name>
USING THE WEB MANAGEMENT INTERFACE
See the section "Displaying and Configuring Syslog Buffer Parameters Using the Web Management Interface" on
page A-7.
Using Syslog
A - 9