HP ProCurve 9304M Installation And Configuration Manual page 262

Installation and Basic Configuration Guide
To display detailed information about 802-1W, using the following command:
HP9300(config)#show 802-1w detail
======================================================================
VLAN 1 - MULTIPLE SPANNING TREE (MSTP - IEEE 802.1W) ACTIVE
======================================================================
BridgeId 800000e080541700, forceVersion 2, txHoldCount 3
Port 1 - Role: ROOT - State: FORWARDING
PathCost 200000, Priority 128, AdminOperEdge F, AdminPt2PtMac F
DesignatedPriority - Root: 0x800000e0804c9c00, Bridge: 0x800000e080541700
ActiveTimers - rrWhile 4 rcvdInfoWhile 4
MachineStates - PIM: CURRENT, PRT: ROOT_PORT, PST: FORWARDING
TCM: ACTIVE, PPM: SENDING_STP, PTX: TRANSMIT_IDLE
Received - RST BPDUs 0, Config BPDUs 1017, TCN BPDUs 0
Port 2 - Role: DESIGNATED - State: FORWARDING
PathCost 200000, Priority 128, AdminOperEdge F, AdminPt2PtMac F
DesignatedPriority - Root: 0x800000e0804c9c00, Bridge: 0x800000e080541700
ActiveTimers - helloWhen 0
MachineStates - PIM: CURRENT, PRT: DESIGNATED_PORT, PST: FORWARDING
TCM: ACTIVE, PPM: SENDING_RSTP, PTX: TRANSMIT_IDLE
Received - RST BPDUs 0, Config BPDUs 0, TCN BPDUs 0
Syntax: show 802-1w detail [vlan <vlan-id>]
The vlan <vlan-id> parameter displays 802.1W information for the specified port-based VLAN.
The show spanning-tree 802.1W command shows the following information.
This Field...
VLAN ID
Bridge ID
forceVersion
txHoldCount
Port
8 - 56
Displays...
ID of the VLAN that owns the instance of 802.1W and whether or not it
is active.
ID of the bridge.
the configured version of the bridge:
• 0 – The bridge has been forced to operate in an STP compatible
mode.
• 2 – The bridge has been forced to operate in an 802.1W mode.
The number of BPDUs that can be transmitted per Hello Interval. The
default is 3.
ID of the port in slot#/port# format.