Upgrading The Mp Flash Code; Upgrading The Tsp Flash Code - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
USING THE CLI
To upgrade TSP boot code from a TFTP server, enter a command such as the following:
HP9300# vm copy tftp flash 192.168.1.170 VSB07300.bin boot
Syntax: vm copy tftp flash <ip-addr> <image-file-name> boot
USING THE WEB MANAGEMENT INTERFACE
You cannot perform this procedure using the Web management interface.

Upgrading the MP Flash Code

To upgrade the MP flash code, use the same methods as for any other management module.
USING THE CLI
To upgrade MP flash code (management software) from a TFTP server, enter a command such as the following:
HP9300# copy tftp flash 192.168.1.170 T1RS07300.bin primary
This command copies Layer 2 flash code from a TFTP server into the primary flash memory area for the MP.
When you reload the software, the MP will boot the new code.
Syntax: copy tftp flash <ip-addr> <image-file-name> primary | secondary
To copy flash code from one flash memory area to the other, enter a command such as the following:
HP9300# copy flash flash secondary
This command copies the flash code in the primary flash memory area to the secondary flash memory area for the
MP.
Syntax: copy flash flash primary | secondary
The primary parameter copies the image in the secondary flash area to the primary flash area.
The secondary parameter copies the image in the primary flash area to the secondary flash area.
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Click on the plus sign next to Command in the tree view to expand the list of command options.
3. Click on the plus sign next to TFTP under Command in the tree view to expand the list of TFTP options.
4. Select the Image link to display the TFTP Image panel.
5. Enter the address of the TFTP server in the TFTP Server IP field.
6. Enter the image file name in the Image File Name field.
7. Specify the destination of the image file you are transferring by selecting Primary or Secondary next to Flash.
8. Click on the Copy from Server button to start the file transfer.

Upgrading the TSP Flash Code

To upgrade the TSPs, use the following CLI method.
USING THE CLI
To upgrade the TSPs, enter a command such as the following at the Privileged EXEC level of the CLI:
HP9300# vm copy tftp flash 109.157.22.26 TSP07300.bin primary
This command upgrades the TSPs by copying a flash code image from a TFTP server to the primary flash for
each of the TSPs on the module.
14 - 6