HP ProCurve Installation And Removal

HP ProCurve 8-Port Power Supply Clip
Installation and Removal
HP ProCurve 8-Port Power Supply Clip (5184-5887) is supported for use on the following switches:
HP ProCurve 2615-8-PoE Switch (J9565A)
■
HP ProCurve 2915-8G-PoE Switch (J9562A)
■
N o te
Prior to installing or removing the Power Supply clip assembly, be sure the power adapter and all cables
have been disconnected and removed.
Installation
.
Align the clip with the switch
1
in the orientation shown.
.
2 First, insert two alignment
pins on one side of the clip into
the appropriate holes on the
switch (A).
3. Then, align the two
thumbscrews on the other side
of the clip (B), and secure the
clip onto the switch (C).
C A U T I O N :
Use caution when tightening the thumbscrews to the switch. Using excessive force may damage the thumbscrew
or hole threads.
4. Slide the power adapter into the
retention clip from the side as illustrated.
C A U T I O N :
Do not install or remove the adapter
by lifting the clip and forcing the
adapter directly into, or out of, the
housing area.
© Copyright 2010 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP will
not be liable for technical or editorial errors or omissions contained herein.
A
1
B
Printed in China
March 2010
Manual Part Number: 5998-0408
*5998-0408*
C