HP ProCurve 9304M Installation And Configuration Manual page 448

Installation and Basic Configuration Guide
This time, the CLI accepts the command, and no error message is displayed:
HP9300(config)# interface ethernet 3/11
HP9300(config-if-e100-3/1)# no ip add 20.20.20.69/24
HP9300(config-if-e100-3/1)# ip add 10.10.10.69/24
HP9300(config-if-e100-3/1)
• Always use the end command at the end of the file. The end command must appear on the last line of the
file, by itself.
Loading the Configuration Information into the Running-Config
You can load the configuration information from a TFTP server. To load the file from a TFTP server, use either of
the following commands:
• copy tftp running-config <ip-addr> <filename>
• ncopy tftp <ip-addr> <filename> running-config
Maximum File Sizes for Startup-Config File and Running-Config
Each HP device has a maximum allowable size for the running-config and the startup-config file. If you use TFTP
to load additional information into a device's running-config or startup-config file, it is possible to exceed the
maximum allowable size. If this occurs, you will not be able to save the configuration changes.
The following table lists the maximum size for the running-config and the startup-config file on HP devices.
Product type
9300 series using Management 2
modules or higher
HP 9304M or HP 9308M using a
Management 1 module
Determining the Size of the Running-Config in Releases 07.6.04 and Later
In software releases 07.6.04 and later, the show running-config, write terminal, and show configuration
commands displays the size of the running-config file. In releases prior to 07.6.04, this information was not readily
available.
For example:
HP9300# show running-config
!Building configuration...
!Current configuration : 449 bytes
(remaining lines omitted)
HP9300# show configuration
!Using 449 out of 262142 bytes
(remaining lines omitted)
NOTE: The lines displaying the size of the running-config are not actually part of the running-config itself.
14 - 16
a.The running-config and startup-config file can each be the size listed.
The maximum size is not the maximum combined size for the running­
config and startup-config files.
Maximum running-config and
a
startup-config file sizes
256K
128K