HP ProCurve 9304M Installation And Configuration Manual page 259

USING THE CLI
To display a summary of 802-1W, use the following command:
HP9300(config)#show 802-1w
--- VLAN 1 [ STP Instance owned by VLAN 1 ] --------------------------- -
VLAN 1 BPDU cam_index is 2 and the IGC and DMA master Are(HEX) 0 1 2 3
Bridge IEEE 802.1W Parameters:
Bridge Bridge
Identifier MaxAge
hex sec
800000e080541700 20
RootBridge RootPath
Identifier Cost
hex
800000e0804c9c00 200000
Port IEEE 802.1W Parameters:
<--- Config Params -->|<-------------- Current state ----------------->
Port Pri PortPath P2P Edge Role
Num Cost
1 128 200000
2 128 200000
3 128 200000
4 128 200000
Syntax: show 802-1w [vlan <vlan-id>]
The vlan <vlan-id> parameter displays 802.1W information for the specified port-based VLAN.
The show 802.1w display command shows the information listed in Table 2.
This Field...
VLAN ID
Bridge IEEE 802.1W Parameters
Bridge Identifier
Bridge Max Age
Bridge Hello
Bridge FwdDly
Configuring Spanning Tree Protocol (STP) and Advanced STP Features
Bridge Bridge Force
Hello FwdDly Version Hold
sec sec
2 15
DesignatedBri-
dge Identifier
hex
800000e0804c9c00
Mac Port
F F ROOT
F F DESIGNATED FORWARDING 200000
F F DESIGNATED FORWARDING 200000
F F BACKUP
Table 2: CLI Display of 802.1W Summary
Displays...
The port-based VLAN that owns the STP instance. VLAN 1 is the
default VLAN. If you have not configured port-based VLANs on this
device, all 802.1W information is for VLAN 1.
The ID of the bridge.
The configured max age for this bridge. The default is 20.
The configured hello time for this bridge.The default is 2.
The configured forward delay time for this bridge. The default is 15.
tx
cnt
Default 3
Root Max Fwd
Port Age Dly
sec sec
1 20 15
State Designa- Designated
ted cost bridge
FORWARDING 0
DISCARDING 200000
Hel
lo
sec
2
800000e0804c9c00
800000e080541700
800000e080541700
800000e080541700
8 - 53