HP ProCurve 9304M Installation And Configuration Manual page 480

Installation and Basic Configuration Guide
Message Level Message
Notification OSPF intf rcvd bad pkt: Invalid packet size,
rid <ip-addr>, intf addr <ip-addr>, pkt size
<num>, checksum <num>, pkt src addr <ip­
addr>, pkt type <type>
Notification VRRP intf state changed,
intf <portnum>, vrid <virtual-router-id>,
state <vrrp-state>
Notification BGP Peer <ip-addr> UP (ESTABLISHED)
Notification BGP Peer <ip-addr> DOWN (IDLE)
Notification Local ICMP exceeds <burst-max> burst
packets, stopping for <lockup> seconds!!
Notification Local TCP exceeds <burst-max> burst
packets, stopping for <lockup> seconds!!
A - 28
Table A.2: HP Syslog Messages (Continued)
Explanation
The device received an OSPF packet with
an invalid packet size.
The parameters are the same as for the Bad
Checksum message.
A state change has occurred in a Virtual
Router Redundancy Protocol (VRRP)
interface.
The <portnum> is the port.
The <virtual-router-id> is the virtual router ID
(VRID) configured on the interface.
The <vrrp-state> can be one of the following:
• init
• master
• backup
• unknown
Indicates that a BGP4 neighbor has come
up.
The <ip-addr> is the IP address of the
neighbor's BGP4 interface with the HP
device.
Indicates that a BGP4 neighbor has gone
down.
The <ip-addr> is the IP address of the
neighbor's BGP4 interface with the HP
device.
The number of ICMP packets exceeds the
<burst-max> threshold set by the ip icmp
burst command. The HP device may be the
victim of a Denial of Service (DoS) attack.
All ICMP packets will be dropped for the
number of seconds specified by the
<lockup> value. When the lockup period
expires, the packet counter is reset and
measurement is restarted.
The number of TCP SYN packets exceeds
the <burst-max> threshold set by the ip tcp
burst command. The HP device may be the
victim of a TCP SYN DoS attack.
All TCP SYN packets will be dropped for the
number of seconds specified by the
<lockup> value. When the lockup period
expires, the packet counter is reset and
measurement is restarted.