HP ProCurve 9304M Installation And Configuration Manual page 261

This Field...
Hello
Port IEEE 802.1W Parameters
Port Num
Pri
Port Path Cost
P2P Mac
Edge port
Role
State
Designated Cost
Designated Bridge
Configuring Spanning Tree Protocol (STP) and Advanced STP Features
Table 2: CLI Display of 802.1W Summary (Continued)
Displays...
The hello value derived from the Root port. It is the number of
seconds between two Hello packets.
The port number shown in a slot#/port# format.
The configured priority of the port. The default is 128 or 0x80.
The configured path cost on a link connected to this port.
Indicates if the point-to-point-mac parameter is configured to be a
point-to-point link:
• T – The link is configured as a point-to-point link.
• F – The link is not configured as a point-to-point link. This is the
default.
Indicates if the port is configured as an operational Edge port:
• T – The port is configured as an Edge port.
• F – The port is not configured as an Edge port. This is the default.
The current role of the port:
• R oot
• Designated
• Alternate
• B ackup
• Disabled
Refer to "Bridges and Bridge Port Roles" on page 8-23 for definitions
of the roles.
The port's current 802.1W state. A port can have one of the following
states:
• F orwarding
• Discarding
• Learning
• Disabled
Refer to "Bridge Port States" on page 8-27 and "Edge Port and Non-
Edge Port States" on page 8-27.
The best root path cost that this port received, including the best root
path cost that it can transmit.
The ID of the bridge that sent the best RST BPDU that was received
on this port.
8 - 55