HP ProCurve 9304M Installation And Configuration Manual page 427

Displaying Neighbor Information
To display a summary list of all the HP neighbors that have sent FDP updates to this HP device, enter the
following command:
HP9300A# show fdp neighbor
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
(*) indicates a CDP device
Device ID
-------------- ------------ ------ ---------- ----------- ------------ -
HP 9300 seriesB
Syntax: show fdp neighbor [ethernet <portnum>] [detail]
The ethernet <portnum> parameter lists the information only for updates received on the specified interface.
The detail parameter lists detailed information for each device.
The show fdp neighbor command, without optional parameters, displays the following information.
Table 13.1: Summary FDP and CDP Neighbor Information
This Line...
Device ID
Local Int
Holdtm
Capability
Platform
Port ID
To display detailed information, enter the following command:
HP9300A# show fdp neighbor detail
Device ID: HP 9300 seriesB configured as default VLAN1, tag-type8100
Entry address(es):
Platform: HP 9300 series Router,
Interface: Eth 2/9
Port ID (outgoing port): Eth 2/9 is TAGGED in following VLAN(s):
9 10 11
Holdtime : 176 seconds
Version :
HP Version 07.6.01b1T53 Compiled on Aug 29
2002 at 10:35:21 labeled as H2R07601b1
Enabling the FDP and Reading Cisco Discovery Protocol (CDP) Packets
S - Switch, H - Host, I - IGMP, r - Repeater
Local Int Holdtm Capability Platform
Eth 2/9
Displays...
The hostname of the neighbor.
The interface on which this HP device received an FDP or CDP
update for the neighbor.
The maximum number of seconds this device can keep the
information received in the update before discarding it.
The role the neighbor is capable of playing in the network.
The product platform of the neighbor.
The interface through which the neighbor sent the update.
Capabilities: Router
178 Router HP 9300 series Rou Eth 2/9
Port ID
13 - 3