HP ProCurve 9304M Installation And Configuration Manual page 459

the most recent message, at the top of the list of messages, was generated when the device had been running for
21 days, seven hours, two minutes, and 40 seconds.
HP9300(config)# show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 38 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Dynamic Log Buffer (50 entries):
21d07h02m40s:warning:list 101 denied tcp 209.157.22.191(0)(Ethernet 4/18
0010.5a1f.77ed) -> 198.99.4.69(http), 1 event(s)
19d07h03m30s:warning:list 101 denied tcp 209.157.22.26(0)(Ethernet 4/18
0010.5a1f.77ed) -> 198.99.4.69(http), 1 event(s)
17d06h58m30s:warning:list 101 denied tcp 209.157.22.198(0)(Ethernet 4/18
0010.5a1f.77ed) -> 198.99.4.69(http), 1 event(s)
Displaying and Configuring Syslog Buffer Parameters Using the Web
Management Interface
To configure Syslog parameters using the Web management interface, use the following procedure:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select Management from the System configuration sheet to display the Management panel.
3. Select the System Log link to display the following panel.
4. Select Disable or Enable next to Logging to disable or enable the Syslog service on the device. The service
is enabled by default.
5. Optionally change the number of entries the local Syslog buffer can hold. The buffer size can be from
1 – 100. The default is 50.
Using Syslog
A - 7