Configuring An Ipx Network Vlan - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
sub-net protocol VLAN (not a protocol, IPX network, or AppleTalk cable VLAN).
5. Enter the VLAN ID that will contain the IP sub-net VLAN in the VLAN ID field.
6. Enter a name for the VLAN in the Protocol_VLAN_Name field.
7. Select the virtual routing interface from the Router_Interface pulldown list if you configured a virtual routing
interface for routing into and out of the VLAN.
8. Enter the IP address of the VLAN in the IP_Address field.
9. Enter the network mask in the Mask field.
10. Specify the port that are members for the VLAN:
• Select Dynamic Port if you want the port membership to be dynamic. For information, see "Dynamic
Ports" on page 11-9.
• Click the Change Static Members button if you want to configure static ports. For information, see "Static
Ports" on page 11-10.
• Click the Change Exclude Members button if you want to explicitly exclude some ports. For information,
see "Excluded Ports" on page 11-10.
NOTE: All the ports must be members of the port-based VLAN that contains this IP sub-net VLAN. See
"Layer 3 Protocol-Based VLANs" on page 11-3.
11. Click the Add button (if you are adding a new VLAN) or the Modify button (if you are modifying an existing
VLAN) to save the change to the device's running-config file.
12. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.

Configuring an IPX Network VLAN

1. Log on to the device using a valid user name and password for read-write access.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to VLAN in the tree view to expand the list of VLAN option links.
11 - 60