HP ProCurve 9304M Installation And Configuration Manual page 205

Table 7.7: CLI Display of Link Aggregation Information (Continued)
This Field...
Ope
Displaying Trunk Group and LACP Status Information
Use the show trunk command to determine the status of LACP. See "Displaying Trunk Group Configuration
Information" on page 7-19.
Clearing the Negotiated Link Aggregations
When a group of ports negotiates a trunk group configuration, the software stores the negotiated configuration in a
table. You can clear the negotiated link aggregation configurations from the software. When you clear the
information, the software does not remove link aggregation parameter settings you have configured. Only the
configuration information negotiated using LACP is removed.
NOTE: The software automatically updates the link aggregation configuration based on LACPDU messages.
However, clearing the link aggregation information can be useful if you are troubleshooting a configuration.
To clear the link aggregation information, use the following CLI method.
USING THE CLI
To clear the link aggregation information, enter the following command at the Privileged EXEC level of the CLI:
HP9300# clear link-aggregate
Syntax: clear link-aggregate
Configuring Trunk Groups and Dynamic Link Aggregation
Displays...
• Ope (operational) - The port is operating normally.
• Ina (inactive) - The port is inactive because the port on the other
side of the link is down or has stopped transmitting LACP
packets.
• Blo (blocked) - The port is blocked because the adjacent port is
not configured with link aggregation or because it is not able to
join a trunk group. To unblock the port and bring it to an
operational state, enable link aggregation on the adjacent port
and ensure that the ports have the same key.
7 - 37