Displaying Switchover Messages - HP ProCurve 9304M Installation And Configuration Manual

USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Click on the Module link to display the Module panel, as shown in the following example.
The Status column shows the module status. The redundant management modules can have one of the following
statuses:
• ACTIVE – The module is currently the active management module.
• STANDBY – The module is the standby management module.
The statuses above apply only to management modules. The following statuses apply only to host modules:
• FAILED – This status applies only to host modules, not to management modules. This status indicates that
the host module failed to come up.
• OK – This status applies only to host modules, not to management modules. This status indicates that the
module came up and is operating normally.

Displaying Switchover Messages

You can determine whether a switchover has occurred by viewing the system log or the traps logged on an SNMP
trap receiver.
Using Redundant Management Modules
3 - 9