HP ProCurve 9304M Installation And Configuration Manual page 224

Routing switches
Hide thumbs Also See for ProCurve 9304M:
Table of Contents

Advertisement

Installation and Basic Configuration Guide
USING THE CLI
To display information for a specific port, enter a command such as the following at any level of the CLI:
HP9300(config)# show interface ethernet 3/11
FastEthernet3/11 is up, line protocol is up
Hardware is FastEthernet, address is 00e0.52a9.bb49 (bia 00e0.52a9.bb49)
Configured speed auto, actual 100Mbit, configured duplex fdx, actual fdx
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
STP configured to ON, priority is level0, flow control enabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
MTU 1518 bytes, encapsulation ethernet
5 minute input rate: 352 bits/sec, 0 packets/sec, 0.00% utilization
5 minute output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
1238 packets input, 79232 bytes, 0 no buffer
Received 686 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 ignored
529 multicast
918 packets output, 63766 bytes, 0 underruns
0 output errors, 0 collisions
The STP information is shown in bold type in this example.
Syntax: show interfaces [ethernet <portnum>] | [loopback <num>] | [slot <slot-num>] | [ve <num>] | [brief]
You also can display the STP states of all ports by entering a command such as the following, which uses the
br i e f parameter:
HP9300(config)# show interface brief
Port
Link State
1/1
Down None
1/2
Down None
1/3
Down None
1/4
Down None
1/5
Down None
1/6
Down None
1/7
Down None
1/8
Down None
.
. some rows omitted for brevity
.
3/10
Down None
3/11
Up
Forward
In this example, only one port, 3/11, is forwarding traffic toward the root bridge.
USING THE WEB MANAGEMENT INTERFACE
To display STP information for a specific port, use the same method as the one described in "Displaying STP
Information for an Entire Device" on page 8-8:
8 - 18
Dupl Speed Trunk Tag Priori MAC
None None
None
No
None None
None
No
None None
None
No
None None
None
No
None None
None
No
None None
None
No
None None
None
No
None None
None
No
None None
None
No
Full 100M
None
No
level0 00e0.52a9.bb00
level0 00e0.52a9.bb01
level0 00e0.52a9.bb02
level0 00e0.52a9.bb03
level0 00e0.52a9.bb04
level0 00e0.52a9.bb05
level0 00e0.52a9.bb06
level0 00e0.52a9.bb07
level0 00e0.52a9.bb4a
level0 00e0.52a9.bb49
Name

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 9304M and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents