NOTE: After you convert the VLAN, the VLAN name changes from "'GVRP_VLAN_<vlan-id>" to
"STATIC_VLAN_<vlan-id>".
Displaying GVRP Information
You can display the following GVRP information:
•
GVRP configuration information
•
GVRP VLAN information
•
GVRP statistics
•
CPU utilization statistics
•
GVRP diagnostic information
Displaying GVRP Configuration Information
To display GVRP configuration information, enter a command such as the following:
HP9300(config)# show gvrp
GVRP is enabled on the system
GVRP BASE VLAN ID
GVRP MAX Leaveall Timer
GVRP Join Timer
GVRP Leave Timer
GVRP Leave-all Timer
===========================================================================
Configuration that is being used:
block-learning ethe 1/3
block-applicant ethe 2/7 ethe 2/11
enable ethe 1/1 to 1/7 ethe 2/1 ethe 2/7 ethe 2/11
===========================================================================
Spanning Tree: SINGLE SPANNING TREE
Dropped Packets Count: 0
===========================================================================
Number of VLANs in the GVRP Database: 15
Maximum Number of VLANs that can be present: 4095
===========================================================================
Syntax: show gvrp [ethernet <port-num>]
Configuring GARP VLAN Registration Protocol (GVRP)
: 4093
: 300000 ms
: 200 ms
: 600 ms
: 10000 ms
12 - 9
Need help?
Do you have a question about the ProCurve 9304M and is the answer not in the manual?