Clearing The Syslog Messages From The Local Buffer; Syslog Messages - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
HP9300# show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 3 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet Lab2, state up
Dec 15 18:45:15:I:Warm start

Clearing the Syslog Messages from the Local Buffer

To clear the Syslog messages stored in the HP device's local buffer, use one of the following methods:
USING THE CLI
HP9300# clear logging
Syntax: clear logging
USING THE WEB MANAGEMENT INTERFACE
To clear Syslog messages using the Web management interface, use the following procedure:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Command in the tree view to display the command options.
3. Select the Clear link to display the Clear panel.
4. Click on the checkbox next to System Logging to place a checkmark in the box.
5. Click Apply to clear the log.

Syslog Messages

Table A.2 lists all of the Syslog messages. The messages are listed by message level, in the following order:
• Emergencies (none)
• A lerts
• Critical (none)
• E rrors
• Warnings
• Notifications
• Informational
A - 12