HP ProCurve 9304M Installation And Configuration Manual page 124

Installation and Basic Configuration Guide
The following table describes the information displayed by the show sntp associations command.
This Field...
(leading character)
address
ref clock
st
when
poll
delay
disp
To display information about SNTP status, enter the following command:
HP9300# show sntp status
Clock is unsynchronized, stratum = 0, no reference clock
precision is 2**0
reference time is 0
clock offset is 0.0
root dispersion is 0.0
Syntax: show sntp status
The following table describes the information displayed by the show sntp status command.
This Field...
unsynchronized
synchronized
stratum
reference clock
precision
reference time
clock offset
root delay
root dispersion
6 - 12
Table 6.1: Output from the show sntp associations command
Displays...
One or both of the following:
* Synchronized to this peer
~ Peer is statically configured
IP address of the peer
IP address of the peer's reference clock
NTP stratum level of the peer
Amount of time since the last NTP packet was received from the peer
Poll interval in seconds
Round trip delay in milliseconds
Dispersion in seconds
.0
msec, root delay is 0.0
msec, peer dispersion is 0.0
Table 6.2: Output from the show sntp status command
Indicates...
System is not synchronized to an NTP peer.
System is synchronized to an NTP peer.
NTP stratum level of this system
IP Address of the peer (if any) to which the unit is synchronized
Precision of this system's clock (in Hz)
Reference time stamp
Offset of clock to synchronized peer
Total delay along the path to the root clock
Dispersion of the root path
msec
msec