HP ProCurve 9304M Installation And Configuration Manual page 126

Installation and Basic Configuration Guide
Although SNTP servers typically deliver the time and date in Greenwich Mean Time (GMT), you can configure the
Routing Switch to adjust the time for any one-hour offset from GMT or for one of the following U.S. time zones:
• US Pacific (default)
• A laska
• Aleutian
• Arizona
• Central
• East-Indiana
• E astern
• H awaii
• Michigan
• Mountain
• P acific
• Samoa
The default is US Pacific.
To change the time zone to Australian East Coast time (which is normally 10 hours ahead of GMT), enter the
following command:
HP9300(config)# clock timezone gmt gmt+10
Syntax: clock timezone gmt gmt | us <time-zone>
You can enter one of the following values for <time-zone>:
• US time zones (us ): alaska, aleutian, arizona, central, east-indiana, eastern, hawaii, michigan, mountain,
pacific, samoa.
• GMT time zones (gm t ): gmt+12, gmt+11, gmt+10...gmt+01, gmt+00, gmt-01...gmt-10, gmt-11, gmt-12.
USING THE WEB MANAGEMENT INTERFACE
To set the local time for the system:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the Clock link to display the Clock panel, shown below.
3. Select the time zone by selecting the offset from Greenwich Mean Time that applies to your time zone. For
example, to set your device to California time, select GMT-08, which means Greenwich Mean Time minus
eight hours.
6 - 14