HP ProCurve 9304M Installation And Configuration Manual page 399

4. Click on the Protocol link.
• If the device does not have any protocol VLANs, the Protocol VLAN configuration panel is displayed, as
shown in the following example.
• If at least one protocol VLAN is already configured and you are adding a new one, click on the IPX
Network link to display the IP Sub-net Protocol VLAN configuration panel.
• If you are modifying an existing protocol VLAN, click on the Modify button to the right of the row
describing the VLAN to display the configuration panel for the type of VLAN you are modifying. The
following example shows the IPX Network Protocol VLAN configuration dialog, used for configuring an
IPX network protocol VLAN (not a protocol, IP sub-net, or AppleTalk cable VLAN).
5. Enter the VLAN ID that will contain the IPX network VLAN in the VLAN ID field.
6. Enter a name for the VLAN in the Protocol_VLAN_Name field.
7. Select the virtual routing interface from the Router_Interface pulldown list if you configured a virtual routing
interface for routing into and out of the VLAN.
8. Select the encapsulation type from the Frame_Type field's pulldown list.
9. Enter the IPX network address of the VLAN in the Network field.
10. Specify the port that are members for the VLAN:
• Select Dynamic Port if you want the port membership to be dynamic. For information, see "Dynamic
Ports" on page 11-9.
• Click the Change Static Members button if you want to configure static ports. For information, see "Static
Ports" on page 11-10.
• Click the Change Exclude Members button if you want to explicitly exclude some ports. For information,
see "Excluded Ports" on page 11-10.
NOTE: All the ports must be members of the port-based VLAN that contains this IPX network VLAN. See
"Layer 3 Protocol-Based VLANs" on page 11-3.
Configuring Virtual LANs (VLANs)
11 - 61