HP ProCurve 9304M Installation And Configuration Manual page 330

Installation and Basic Configuration Guide
• The interfaces on a VSRP-aware device that are active for the VRID
Displaying VRID Information
To display VSRP information, enter the following command:
HP9300(config-vlan-200-vrid-1)# show vsrp vrid 1
Total number of VSRP routers defined: 2
VLAN 200
auth-type no authentication
VRID 1
State Administrative-status Advertise-backup Preempt-mode save-current
standby enabled
Parameter
priority
hello-interval
dead-interval
hold-interval
initial-ttl
next hello sent in 00:00:00.8
Member ports:
Operational ports: ethe 1/1 to 1/4
Forwarding ports:
Syntax: show vsrp [vrid <num> | vlan <vlan-id>]
This display shows the following information when you use the vrid <num> or vlan <vlan-id> parameter. For
information about the display when you use the aware parameter, see "Displaying the Active Interfaces for a
VRID" on page 10-36.
This Field...
Total number of VSRP routers
defined
VLAN
auth-type
VRID parameters
VRID
state
10 - 34
disabled
Configured Current
100 80
1 1
3 3
3 3
2 2
ethe 1/1 to 1/5
ethe 1/1 to 1/4
Table 10.5: CLI Display of VSRP VRID or VLAN Information
Displays...
The total number of VRIDs configured on this device.
The VLAN on which VSRP is configured.
The authentication type in effect on the ports in the VSRP VLAN.
The VRID for which the following information is displayed.
This device's VSRP state for the VRID. The state can be one of the
following:
• initialize – The VRID is not enabled (activated). If the state
remains "initialize" after you activate the VRID, make sure that the
VRID is also configured on the other routers and that the routers
can communicate with each other.
Note: If the state is "initialize" and the mode is incomplete, make
sure you have specified the IP address for the VRID.
• standby – This device is a Backup for the VRID.
• master – This device is the Master for the VRID.
true
Unit
(100-0)*(4.0/5.0)
sec/1
sec/1
sec/1
hops
false