HP ProCurve 9304M Installation And Configuration Manual page 162

Installation and Basic Configuration Guide
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Advance link to display the following panel.
3. Edit the value in the Temperature Warning Threshold field to change the warning temperature.
4. Edit the value in the Temperature Shutdown Threshold field to change the shutdown temperature.
5. Click the Apply button to send the configuration change to the active module's running-config file.
6. If you want the change to remain in effect following the next system reload, select the Save link to save the
configuration change to the startup-config file.
Changing the Chassis Polling Interval
The software reads the temperature sensor and polls other hardware sensors according to the value set for the
chassis poll time, which is 60 seconds by default. You can change chassis poll time using the CLI.
USING THE CLI
To change the chassis poll time, enter a command such as the following at the global CONFIG level of the CLI:
HP9300(config)# chassis poll-time 200
Syntax: chassis poll-time <value>
The <value> can be 0 – 65535.
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
6 - 50