HP ProCurve 9304M Installation And Configuration Manual page 103

Routing switches
Hide thumbs Also See for ProCurve 9304M:
Table of Contents

Advertisement

NOTE: If the ports on a module are not up, the output says "will be processed" instead of "is processed" and
the weight is listed as "0". In this case, the T-Flow reserves a TSP for the module but does not add weight for
the module's ports to the reserved TSP.
NOTE: For reference, this example matches "Example Configuration 1" on page 4-4.
When per-DMA TSP load sharing is enabled on the device, the show vm-map command displays static TSP
assignments. For example:
HP9300# show vm-map
slot 1 (weight 80 x 100M):
e
1/5-1/6
is processed by TSP processor 4/2
e
1/7-1/8
is processed by TSP processor 4/3
slot 2 (weight 24 x 100M) is processed by TSP processor 4/1
Static configuration:
slot 1 (weight 80 x 100M):
e
1/1-1/2
is processed by TSP processor 4/3
e
1/3-1/4
is processed by TSP processor 4/1
In the example above, per-DMA TSP load sharing has been enabled on the device.
supports per-DMA TSP load sharing, but the module in slot 2 does not. The T-Flow is located in slot 4.
On the module in slot 1, the DMAs controlling ports 1 – 2 and 3 – 4 have been statically assigned to TSPs. The
DMAs controlling the other ports on the module have been dynamically assigned to TSPs based on the weight of
the DMAs.
All of the ports on the module in slot 2 are assigned to TSP 4/1. Since the module does not support per-DMA TSP
load sharing, all of its ports are assigned to a single TSP.
Using the T-Flow Redundant Management Module
The module in slot 1
4 - 15

Advertisement

Table of Contents
loading

Table of Contents