HP ProCurve 9304M Installation And Configuration Manual page 479

Message Level Message
Notification OSPF LSDB overflow, rid <router­id>,
limit <num>
Notification OSPF LSDB approaching overflow,
rid <router­id>, limit <num>
Notification OSPF intf rcvd bad pkt: Bad Checksum, rid
<ip-addr>, intf addr <ip-addr>, pkt size
<num>, checksum <num>, pkt src addr <ip­
addr>, pkt type <type>
Notification OSPF intf rcvd bad pkt: Bad Packet type, rid
<ip-addr>, intf addr <ip-addr>, pkt size
<num>, checksum <num>, pkt src addr <ip­
addr>, pkt type <type>
Notification OSPF intf rcvd bad pkt: Unable to find
associated neighbor, rid <ip-addr>, intf addr
<ip-addr>, pkt size <num>, checksum
<num>, pkt src addr <ip-addr>, pkt type
<type>
Table A.2: HP Syslog Messages (Continued)
Explanation
A Link State Database Overflow (LSDB)
condition has occurred.
The <router­id> is the router ID of the HP
device.
The <num> is the number of LSAs.
The software is close to an LSDB condition.
The <router­id> is the router ID of the HP
device.
The <num> is the number of LSAs.
The device received an OSPF packet that
had an invalid checksum.
The rid <ip-addr> is HP device's router ID.
The intf addr <ip-addr> is the IP address of
the HP interface that received the packet.
The pkt size <num> is the number of bytes in
the packet.
The checksum <num> is the checksum
value for the packet.
The pkt src addr <ip-addr> is the IP address
of the neighbor that sent the packet.
The pkt type <type> is the OSPF packet type
and can be one of the following:
• hello
• database description
• link state request
• link state update
• link state acknowledgement
• unknown (indicates an invalid packet
type)
The device received an OSPF packet with
an invalid type.
The parameters are the same as for the Bad
Checksum message. The pkt type <type>
value is "unknown", indicating that the packet
type is invalid.
The neighbor IP address in the packet is not
on the HP device's list of OSPF neighbors.
The parameters are the same as for the Bad
Checksum message.
Using Syslog
A - 27