HP ProCurve 9304M Installation And Configuration Manual page 84

Installation and Basic Configuration Guide
When you synchronize software between the modules, the active module copies its software to the standby
module.
To display the current file synchronization settings, enter the following command:
HP9300# sync-standby
Sync code image: TRUE
Sync config data: TRUE
Sync boot image: FALSE
Running-config sync interval is 10 seconds
NOTE: The values shown in this example are the default values.
Syntax: sync-standby
NOTE: The sync-standby command has optional parameters. If you enter one of the parameters, the CLI
synchronizes software between the modules. To display the synchronization settings instead of synchronizing
software, enter the command without parameters.
This display shows the following information.
This Field...
Sync code image
Sync config data
Sync boot image
Running-config sync interval
3 - 12
Table 3.1: CLI Display of Synchronization Settings
Displays...
Indicates whether the active module is configured to automatically
synchronize its flash code with the standby module. The value can be
one of the following:
• FALSE – The code is not automatically synchronized.
• TRUE – The code is automatically synchronized.
Indicates whether the active module is configured to automatically
synchronize its startup-config file with the standby module. The value
can be one of the following:
• FALSE – The startup-config file is not automatically
synchronized.
• TRUE – The startup-config file is automatically synchronized.
Indicates whether the active module is configured to automatically
synchronize its boot code with the standby module. The value can be
one of the following:
• FALSE – The boot code is not automatically synchronized.
• TRUE – The boot code is automatically synchronized.
Indicates whether the active module is configured to automatically
synchronize its running-config with the standby module. The value
can be one of the following:
• FALSE – The running-config is not automatically synchronized.
• TRUE – The running-config is automatically synchronized.