HP ProCurve 9304M Installation And Configuration Manual page 76

Installation and Basic Configuration Guide
USING THE CLI
To prepare slot 1 to receive an eight-port Gigabit redundant management module, enter the following commands
at the global CONFIG level:
HP9300(config)# module 1 8-port-gig-management-module
HP9300(config)# write memory
Syntax: module <slot-num> <module-type>
The <slot-num> parameter specifies the chassis slot to contain the module:
• Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
• Slots in an 8-slot chassis are numbered 1 – 8, from left to right.
• Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
In the current software release, the <module-type> for a Redundant Management module can be one of the
following:
• 0-port-management-module – J4847A
• 8-port-gig-management-module – J4845A or J4846A
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Click on the Module link to display the Module panel, as shown in the following example.
3 - 4