Displaying Mrp Information - HP ProCurve 9304M Installation And Configuration Manual

Displaying MRP Diagnostics
To display MRP diagnostics results, enter the following command on the Master node:
HP9300(config)# show metro 2 diag
Metro Ring 2 - CustomerA
=============
diagnostics results
Ring Diag
id state
2 enabled
Diag frame sent
1230
Syntax: show metro <ring-id> diag
This display shows the following information.
Table 10.2: CLI Display of MRP Ring Diagnostic Information
This Field...
Ring id
Diag state
RHP average time
Recommended hello time
Recommended Prefwing time
Diag frame sent
Diag frame lost
If the recommended hello time and preforwarding time are different from the actual settings and you want to
change them, see "Configuring MRP" on page 10-11.

Displaying MRP Information

You can display the following MRP information:
• Topology group configuration information
• Ring configuration information and statistics
Displaying Topology Group Information
To display topology group information, enter the following command:
Syntax: show topology-group [<group-id>]
See "Displaying Topology Group Information" on page 10-3 for more information.
RHP average Recommended
time(microsec) hello time(ms)
125 100
Diag frame lost
0
Displays...
The ring ID.
The state of ring diagnostics.
The average round-trip time for an RHP packet on the ring. The
calculated time has a granularity of 1 microsecond.
The hello time recommended by the software based on the RHP
average round-trip time.
The preforwarding time recommended by the software based on the
RHP average round-trip time.
The number of diagnostic RHPs sent for the test.
The number of diagnostic RHPs lost during the test.
Configuring Metro Features
Recommended
Prefwing time(ms)
300
10 - 13