HP ProCurve 9304M Installation And Configuration Manual page 80

Installation and Basic Configuration Guide
Status LED
If you are located near the device, you can determine which redundant management module is currently the active
module and which one is the standby by observing the upper green LED to the right of the serial management
port. If the upper green LED is lit, the module is currently the active redundant management module. If the LED
is dark, the module is the standby. The lower green LED indicates the power status. If the lower LED is dark, the
module is not receiving power. (A module without power will not function as the active or standby module.)
Software
You can display status information for the modules using either of the following methods.
NOTE:
• Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
• Slots in an 8-slot chassis are numbered 1 – 8, from top to bottom.
• Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
USING THE CLI
To display the status of a redundant management module using the CLI, enter the following command at any CLI
level:
HP9300> show module
Module
S1: 8 Port Gig Management Module
S2: 24 Port Copper Switch Module
S3: 24 Port Copper Switch Module
S4: 24 Port Copper Switch Module
S5: B8GMR Fiber8 port Gig Management Module
S6: 24 Port Copper Module
S7: 24 Port Copper Module
S8: 24 Port Copper Module
Syntax: show module
NOTE: The module descriptions do not distinguish between SX and LX ports.
The Status column shows the module status. The redundant management modules can have one of the following
statuses:
• ACTIVE – The module is currently the active management module.
• STANDBY – The module is the standby management module.
• COMING UP – The module is coming up as the standby module. This status can be observed during
switchover.
The statuses above apply only to management modules. The following statuses apply only to host modules:
• FAILED – This status applies only to host modules, not to management modules. This status indicates that
the host module failed to come up.
• OK – This status applies only to host modules, not to management modules. This status indicates that the
module came up and is operating normally.
3 - 8
Status Ports Starting MAC
ACTIVE 8
OK 24
OK 24
OK 24
STANDBY
OK 24 00e0.5202.a2d4
OK 24 00e0.5202.a2d4
OK 24 00e0.5202.a2d4
00e0.5202.a2d4
00e0.5202.a2d4
00e0.5202.a2d4
00e0.5202.a2d4
8 00e0.5202.a334