Ensor - HP ProCurve 9304M Installation And Configuration Manual

/telnet
The results of the search are displayed:
searching...
telnet
temperature
terminal
traceroute
undebug
undelete
whois
write
To display lines containing only a specified search string (similar to the include option for show commands) press
the plus sign key ( + ) at the --More-- prompt and then enter the search string.
--More--, next page: Space, next line: Return key, quit: Control-c
+telnet
The filtered results are displayed:
filtering...
telnet
To display lines that do not contain a specified search string (similar to the exclude option for show commands)
press the minus sign key ( - ) at the --More-- prompt and then enter the search string.
--More--, next page: Space, next line: Return key, quit: Control-c
-telnet
The filtered results are displayed:
filtering...
sync-standby
temperature
terminal
traceroute
undebug
undelete
whois
write
As with the commands for filtering output from show commands, the search string is a regular expression
consisting of a single character or string of characters. You can use special characters to construct complex
regular expressions. See the next section for information on special characters used with regular expressions.
Using Special Characters in Regular Expressions
You use a regular expression to specify a single character or multiple characters as a search string. In addition,
you can include special characters that influence the way the software matches the output against the search
string. These special characters are listed in the following table.
Table 2.5: Special Characters for Regular Expressions
Character Operation
. The period matches on any single character, including a blank space.
For example, the following regular expression matches "aaz", "abz", "acz", and so on, but
not just "az":
a.z
Telnet by name or IP address
temperature sensor commands
display syslog
TraceRoute to IP node
Disable debugging functions (see also 'debug')
Undelete flash card files
WHOIS lookup
Write running configuration to flash or terminal
Telnet by name or IP address
Synchronize active and standby module
temperature sensor commands
display syslog
TraceRoute to IP node
Disable debugging functions (see also 'debug')
Undelete flash card files
WHOIS lookup
Write running configuration to flash or terminal
Installation
2 - 29